· Last updated · 8 min read
By Immediate Restoration Pennsylvania
Ask any Pennsylvania restoration company what fills their schedule in January, and the answer is the same: burst pipes. When an Arctic cold snap parks over the Commonwealth, water inside exposed pipes freezes, expands, and splits the pipe wide open. The cruel part is that the real flooding usually happens later — when the ice thaws and water gushes through the rupture while nobody is home to hear it.
Key Takeaways
- Water expands by about 9 percent when it freezes, and it does so with tremendous force — enough to crack copper, PEX, and galvanized steel alike.
- Walk your house with fresh eyes and look for these usual suspects:
- Do this work in October or November, before the first hard freeze:
- Suspect a frozen pipe when a faucet produces only a trickle, or nothing, during a cold snap.
A single burst pipe can release hundreds of gallons per hour into walls, ceilings, and finished basements, with repair bills commonly running from $5,000 to $25,000 once drying, drywall, and flooring are accounted for. The good news: frozen pipes are among the most preventable water disasters a homeowner can face. Here is how Pennsylvania winters create the problem — and the exact steps that keep your pipes intact.
Why Pennsylvania pipes freeze — and burst
Water expands by about 9 percent when it freezes, and it does so with tremendous force — enough to crack copper, PEX, and galvanized steel alike. But the burst rarely happens at the ice blockage itself. As ice forms, it traps water between the blockage and a closed faucet; pressure in that trapped section can spike past 2,000 psi, and the pipe fails at its weakest point, often several feet from the frozen spot.
Pennsylvania homes are vulnerable for specific reasons: many older houses in Philadelphia, Pittsburgh, and the Lehigh Valley have uninsulated crawl spaces and exterior-wall plumbing; pipes run through unheated garages, attics, and basements; and the state's freeze-thaw cycles mean pipes can sit at the edge of freezing for days before a polar-vortex night pushes them over. Newer construction isn't immune either — pipes on exterior walls in bump-outs and kitchen additions are classic freeze points.
The highest-risk pipes in your home
Walk your house with fresh eyes and look for these usual suspects:
- Exterior-wall plumbing: Kitchen sinks, bathroom vanities, and hose bibs on outside walls — especially in additions and bump-outs.
- Unheated spaces: Crawl spaces, attics, garages, and unfinished basements where temperatures track the outdoors.
- Exterior hose bibs: A garden hose left connected traps water in the pipe all winter. Disconnect every hose in October.
- Vacation or vacant properties: Pipes in homes with the heat turned down or off are sitting ducks during a cold snap.
If you've had a pipe freeze before, it will freeze again at the same spot unless something changes. Mark those locations and treat them first.
Prevention: the fall checklist that works
Do this work in October or November, before the first hard freeze:
- Insulate exposed pipes. Foam pipe sleeves on hot and cold lines in crawl spaces, basements, and garages. For the most vulnerable runs, add UL-listed heat tape or heat cable with a built-in thermostat.
- Seal the cold out. Caulk and insulate gaps where pipes pass through exterior walls, rim joists, and sill plates. Cold air leaking onto a pipe defeats insulation.
- Disconnect hoses and shut off exterior bibs. Drain exterior lines and, if you have interior shutoff valves for hose bibs, close them and leave the outside valve open.
- Keep cabinet doors open. During extreme cold, open vanity and sink cabinet doors on exterior walls so warm room air reaches the pipes.
- Let faucets drip. A pencil-thin stream of water from the faucet farthest from the water main keeps water moving through vulnerable lines on the coldest nights.
- Keep the heat on. Never set the thermostat below 55°F when you're away — 60°F is safer. The fuel savings aren't worth a burst pipe.
- Know your main shutoff. Locate your home's main water shutoff valve now, label it, and make sure everyone in the house can find it. Test that it actually turns.
What to do when a pipe freezes
Suspect a frozen pipe when a faucet produces only a trickle, or nothing, during a cold snap. Act fast:
- Keep the faucet open. Running water — even a drip — helps melt ice and gives expanding water somewhere to go.
- Apply gentle heat. Use a hair dryer, heating pad, or warm (not boiling) towels on the exposed frozen section, working from the faucet back toward the coldest area. Never use a blowtorch or open flame.
- Check the rest of the house. If one pipe froze, others may be close behind. Check every faucet.
- Look for leaks as it thaws. A burst often reveals itself only when the ice melts. Watch the pipe and surrounding areas closely, and have someone ready at the main shutoff.
When a pipe bursts: the first 30 minutes matter
If you discover a burst pipe, shut off the main water valve immediately — this single step can cut your damage in half. Then kill power to affected areas at the breaker if water is near outlets or fixtures, and call a plumber to repair the break. For the water damage itself, call a restoration company right away: standing water soaks into drywall, subfloors, and insulation within hours, and mold follows within days.
Our burst pipe and leak water damage crews are on call 24/7 through Pennsylvania winters. We extract the water, open and dry wall cavities with targeted equipment, verify dryness with moisture meters, and coordinate repairs — from drying and dehumidification to full water damage restoration. Fast action on a burst pipe routinely saves homeowners thousands compared to waiting until morning.
Frequently Asked Questions
At what temperature do pipes freeze in Pennsylvania? Pipes can freeze when temperatures drop into the low 20s °F, especially with wind chill and exposure. Uninsulated pipes in crawl spaces, attics, and exterior walls are at risk any night below about 25°F.
Should I let faucets drip during a freeze? Yes. A slow drip from the faucet farthest from your water main keeps water moving through vulnerable pipes and relieves pressure, which is the most effective short-term defense during extreme cold.
What should I do first if a pipe bursts? Shut off your home's main water valve immediately, then turn off power to the affected area if water is near electrical fixtures. Then call a plumber for the repair and a restoration company for the water damage.
Will my insurance cover burst pipe damage? Most Pennsylvania homeowners policies cover sudden burst-pipe water damage, but not damage from gradual leaks or pipes that froze because you left the heat off. Document everything and file promptly.
For official guidance on preparedness and recovery, see Ready.gov’s winter preparedness resources.
Sources
- https://www.ready.gov/ — Ready.gov’s winter preparedness resources
Related Reading
If this guide helped, these next reads go deeper:
- Sump Pump Failure and Basement Flooding in PA
- Hurricane Ida’s Philly Flooding: Lessons for Homeowners
- Cost of Water Damage Restoration in Pennsylvania
- Burst Pipe & Leak Water Damage Services
- Drying & Dehumidification
Where we help: Erie, PA · Scranton, PA · State College, PA · Altoona, PA

